Coal Briquetting Press Service Life

Coal briquetting press after using for a long time will appear the corresponding problems, After long time use, damage and make repairs the coal briquetting press will wear or obsolescence, then what is the extent considered retirement indicator?

GEMCO Briquetting Press Engineer will give you answers:

1. The outer surface of the hollow shaft grooves, scars or partially worn surface of the inner circle of the situation caused by the hollow shaft deformation, cracks, etc. Then should be replaced.
2. The ring gear rim distortion amount should not exceed 7.5mm.
3. The small amount of wear gear surface should not exceed 30% of the tooth thickness, big tooth wear is greatly tooth thickness at 25% of the surface can be inverted using, 1/2 should be scrapped.
4. Bearing wear is greater than 1/3 of the thickness.

These are the coal briquetting machine scrapped indicators in using, If you have the several problems should be replacement coal briquetting press machine timely, don’t be replaced when the accident occurred, it was too late, timely replacement of scrapped ball press machine to improper misuse of our production. At the same time, we must carry out regular maintenance, so that the life of coal briquetting machine longer.